Recent content by LGoodridge

Oneal, great info, and thanks so much. The unit is at my camp. I will check that ground this weekend. I will let you know.

Gentlemen, My winch is DOA, too. Tried to use it the first time last weekend, and nothing but the solenoid clicking. I got it back to the garage and confirmed power to the winch. I pulled it out, and it's on the bench now. I wanted to bench-test it, too. I connected the negative to the winch...

Clubin, I had about 40miles on them before I broke a ball joint. I monitored trans temps all the time and it stayed cool. What symptoms were you seeing that concerned you.

Thanks for the Tip Oneal. I ordered a Rhino 2.0 drive shaft for it. It too is supposed to be stronger than OEM.

What not to do with your new XD with Duratracs. I was soft snow, hitting it hard, when I hit a hidden boulder. The upper ball joint broke, and the lower A-arm folded like butter. Will need upper and lower A-arms, Tie Rod, and Half shaft at a minimum. Thawing it out now so I can take it apart...

I, too, have the Duratracs on my unit. They are built like a tank. The rear tracks are the same size as the fronts so does not have quite the flotation as the Camso's. I have a set of Camso's on my Can-Am Defender. They work great, too. Duratracs do not have the flotation in deep snow, but I...

I will contact Polaris and speak to Owner on 27th when she goes in for hopefully permanent fix. Been out on the Ice for about three hours today. Transmission light came on again. Cycled engine and it went out. Did not go into safe mode this time. Getting a pretty large cold air infiltration on...

After 3.5 hours of waiting at the dealer, I have a temporary fix. They thought it was an electrical issue at first, but it ended up being a shift linkage issue. I think they had 4 guys troubleshooting it. It turned out that a plastic block in the dash on the shift linkage came off. When it did...

Unfortunately, I am headed to the dealer with my 24 Xtreme with 35 miles on it. Got the transmission dummy light. I turned off the machine and back on, and the light went out. The problem is I am in limp mode. I tried disconnecting the battery for 30 minutes, and that did not work. There are no...

Took her out tonight for a Break-In. I put the magnesium in the tracks and took her on a paved road for about two miles. About 1/2 mile into it, I got an acrid rubber-burning smell. I stopped and inspected all four tracks, felt no hot spots, and kept going. I called Steve at SVI for advice when...

Hello all, new to forum. I just completed my installation of Duratracks. I agree with Adk above on the install. I did it alone in about 7hrs. Yes thats a long time but I had never installed tracks for the first time on a machine. Always initially installed at the dealer. I, too, will be using...