• 🔖 It looks like you are browsing the site as a guest. By registering on the site you can participate on the Internet's largest Polaris Ranger XD 1500 forum. To register, simply Click Here!

Recent content by Mr.C

  1. Mr.C

    2025 XD 1500 Crew Northstar - Rotomax mount

    If you’re asking me, I used the clamps that I attached a link to. They basically just clamp onto the tubes of the spare tire mount. Then the threaded rod goes through a hole of the jack and use the wing nuts to tighten and secure. https://a.co/d/0cOUR88D
  2. Mr.C

    Pandemyk Performance

    I don’t blame you. That’s a long time to be waiting. Part of the reason I haven’t done the gilomen tune yet either.
  3. Mr.C

    Let’s see those camo crew ultimates doing their thing.

    Looks like fun. I saw a young corgi last week and was wondering how the pup was doing.
  4. Mr.C

    Let’s see those camo crew ultimates doing their thing.

    Haha. You couldn’t do that again if you tried.
  5. Mr.C

    New Guy

    Not squirrels so much. But I do like setting up on a meadow/field and taking out some prairie dogs. Or chasing jack rabbits in the desert. Eastern Oregon is great!
  6. Mr.C

    New Guy

    Welcome to the group! You’ve come to the right place to gather information. You’re also in the right state for all your activities. Work keeps me west of the state line.
  7. Mr.C

    Aftermarket Assassins Ranger 1500 install and thoughts

    Dam, I think I’ll hold off on any exhaust at the moment. Hopefully the second one doesn’t do the same.
  8. Mr.C

    Seat belt bypass

    They also make bypass devices for vehicles, just fyi. I haven’t worn a seat belt as a driver in over 30 years. I will wear one in respect, as a passenger in someone’s else’s vehicle.
  9. Mr.C

    Front camera

    I have the Polaris one, the dealer installed it before I picked up my Ranger.
  10. Mr.C

    Diesel Transfer tank to fit in crew bed.

    There’s many different brands out there. I’d look at transfer flow, weathergaurd, deezee, etc. Not sure if any have fork pockets that I’ve seen. I had a 40 gallon slip tank in the bed of my old truck, and it didn’t have fork pockets. I used a GPI brand pump that did 15gpm. As far as a hose goes...
  11. Mr.C

    10 inch Rigid bar mounted front bumper

    I have a rigid bar on my bumper, but it’s wired to a separate switch. I would think if you did it like the dealer says, then yes it should work. I’m looking at purchasing a light bar for my truck that operates either on the bright switch or separately and it’s the same way as your explaining.
  12. Mr.C

    New to the forum

    Welcome to the group!
  13. Mr.C

    Had to make my truck match my Ranger

    That’s a nice trailer!
  14. Mr.C

    Had to make my truck match my Ranger

    As of now, just my fully finished interior 24’ enclosed with my XD. Plus the permanent fixtures. Also have a 20’ flat bed I haul the XD on. But I also haul equipment here and there for personal use. Dump trailers with dirt, rock, gravel. Or sometimes a mini excavator. The way I look at it is...
  15. Mr.C

    Let’s see those camo crew ultimates doing their thing.

    Looks like a great time! Dinner sure looked good! I’d like to come up and play sometime. It’s hard to get a group that big around here for some reason. Plus that’s the wife’s homeland.
Back
Top