Recent content by awickedtruth

I’m guessing that is why they are giving me warranty…. Hopefully the new one is much better… thx

Just got word that Polaris is going to cover this under warranty….

My new 1500 Texas Edition has a crack in the windshield… started just below the wiper motor but overnight it has spread all the way across… I am not a huge fan of the tip out windshield… looking at other options that you may have tried…. Would like to keep the wiper if possible… any input is...

These are the right ends…. Thx so much for the help

Very possible… will get it ordered and try it…. Thx much

Thanks …. Appreciate you trying to help

Thanks…. But I needed to be more specific…. I need the plug that goes on the supply side of the switch…. It is a small square 2 prong plug that attaches to the switch behind the tail light….

I am trying to find the electrical connector that fits the 12 volt port in the bed... The plug is Polaris part number 2416400.... but I want to know the waterproof plug that fits this connector. I am adding a 12 volt cooler in the bed that will run off a second battery in a dual battery...

OK, Curiosity was getting to me so I decided to trace the wires to the 12 volt plug in the dump bed. They run to the plug on the passenger side and attached to the frame above and behind the battery. In the second picture the bottom go to the plug. The brown wire is the negative and the Orange...

I want to use the 12 volt outlet in the bed to power a small electric cooler... but I want to run it off a second battery in a dual battery setup. So I need to tap into the 2 wires that go to the outlet in the bed. It looks like it runs in the harness that goes across the bed and runs up the...

Yes.. single small cable... fits easily thru the grommet behind the gauges on the firewall.

There are only a couple things that I do not like on my Texas Edition... one being the limited amount of space for switches. On my General I had installed an 8 Gang Auxbeam Switch Controller but on the Ranger XD there is only one opening on the dash panel and I did not want to run all the wires...

Looking to add 2ND Battery to my Polaris XD 1500 Texas Edition.. I see that UTV has one available but has anyone seen any others… I do not like the isolator on their kit so looking for other options… thanks in advance

Picked up my new XD 1500 Texas Edition yesterday and getting it street ready… must have a safety triangle… any pics or input on best location for looks and appearance?

Was informed by my dealer that POLARIS accepted my order for the Texas Edition today… 12/15… no idea on led time yet but it is finally on order… central ILLINOIS